Honeycomb oblique pipe packing method of installation - hot method - safety precautions We provide you with honeycomb inclined pipe installation method, hot method, safety precautions and other information: a guardian in place; Large volume will occupy a lot of space, reserved for storage in advance; hot operation 1, open the inclined tube packing packing, the first piece of inclined tube packing flat on the ground, take the second piece of inclined tube packing placed in the first packing Above, check the oblique tube filler incision, we must ensure that the angle of 60 ° and was hexagonal honeycomb, check the correct start hot embossing joints; 2, hexagonal honeycomb at both ends of all the plane contact all hot to be on both sides of the two Plane seam at the junction of more than four points required in the middle of the two inclined tube packing plane welding more than four points to ensure a solid weld; 3, when the attention of the hot rhythm of operation, control the temperature, the number of hot joints shall not be omitted; , Each inclined pipe packing packing as a separate hot-melt unit, after the hot finished neatly stacked on the site; 5, half-way break must be cut off the power of the iron, and to be placed safely; Preparation: 1, hot to the power cable prepared; 2, ready to 500W electric iron 2; 3, to the operator;