Does excess polyaluminum chloride result in effluent? Does excess polyaluminum chloride result in effluent? As the application of aluminum polychloride excellent performance, is commonly used in various types of wastewater efficient water purifying agent, so the use of water treatment sites in the use. However, in general, some problems usually occur during use, such as the effect of using polyaluminum chloride due to some factors and the dosage of some specific uses. Today, the filter water purification here to explain to you is the recent relevant users to consult some of the questions asked in the process mentioned the following points. Consultation questions are as follows: 1 solid aluminum chloride dosing standards have? 2. solid polyaluminum in the process of dilution configuration ratio is better? 3. Solid polyaluminum dosage will affect the color of the effluent? 4. Why polydimethylsiloxane used in the process of adding water become clear, but the factory water turns yellow? Is it because of the reasons for dosage? How to deal with this situation? In fact, these problems are all of the above water purifying agent in the process of using some of the issues that will be involved in today's long-filtering source water purification in this for everyone to solve these problems. 1. If the use of solid polyaluminum chloride for tap water treatment, the best dosage is 20-50Kg dosage per thousand tons, and industrial sewage will have to deal with some of the water quality factors to determine the dosage will be A corresponding increase. 2 solid aluminum chloride diluted to 10% liquid is better to use. 3. Solid polyaluminum chloride in the use of the process, excessive dosage will affect the color of the effluent, it should grasp the proportion of vote. 4. Because polyaluminum chloride is a flocculant, it is for organic matter or inorganic matter in water flocculation accelerated precipitation, due to the lack of polyaluminum chloride in a mineral, with a color and selectivity of the reaction, and floc was Reaction, so cloudy water will become clear. However, if the raw water itself is a color of industrial wastewater, how to deal with polyaluminium chloride are still color, or is anti-color, polyaluminum chloride should be used for the performance of industrial wastewater treatment is not suitable for decoloration. If not, then that is excessive dosing, the introduction of the color of the product. If these above methods do not meet your requirements, please contact us to filter water purification departments, we will conduct a one-on-one technical service exchange.